Skip to main content

The Frog Van - Old Boiler No More

In the continuing saga that is my frog van we left off in my post Getting to Know More About Cars with the van parked in my studio minus one driver seat and radiator.

As mentioned previously I took the radiator in to have it cleaned.

The verdict was, according to the radiator mechanic, that the internal pipes were 95 percent blocked. Overheating problem solved, I guess. Whilst this before and after photo on the right is rather meaningless it does show how painting the thing black can make all the difference. I'm sure that'll help. I wonder if we paid extra for that?

I put the radiator and the engine panel and driver seat back in (thinking I wouldn't need to get down that side of the engine any more), filled the radiator up and gave the van a good run around a few local hills at 80kmph. The good news being that the engine temperature remained constant at its proper level the whole time. Yippee! Old boiler no more!

Next I decided to see what I could do about the fuel problem with the van constantly running on, backfiring (sometimes) and I did notice it was struggling a little again going up hills.

All my online researching suggested starting with the fuel pump and fuel filter. I knew the fuel pump was fine but have no idea when the fuel filter was last changed so put a new one of those on my shopping list. At the same time I checked all the rubber hoses that make up the fuel system and discovered a suspect one right at the base of the carburetor attached to the fuel inlet manifold (I think that's what you call it). Rubber hose added to my shopping list.

I thought I'd remove the old fuel filter easily but it wasn't to be. It was located on the drivers side of the engine so once again I had to pull out the drivers seat and the engine cover panel.

Pulling out the old filter was a little tricky but putting in the new one was easy enough. I bought enough rubber hose to put new hoses on each side of the filter which I cut then let my partner, Enigma, handle attaching them to the filter whilst I went off and made a real mess of replacing the other hose near the carburetor.

The old hose had a definite split. Since this was a vacuum pressure hose it was clear to me that this could be the reason for the van once again struggling with hills. You'd think replacing a pipe would be simple but, since this is me we're talking about, I managed to break the metal connection point right off, putting on the new hose.

After fitting the new fuel filter my partner and I rushed down to the car shop with the broken part for advice. The man there suggested we could either fit a new similar (but not the same part) brass part for AU$42.00 or we could try gluing the old part back together with a product called 'permaweld' for AU$9.95. No prizes for which we chose.

The Permaweld glue needed to be left overnight for maximum strength so I glued the part and then tidied everything up for the day. If you look at the photo on the right you can see the part I'm talking about. The curved bit on the top, angling to the right, is what broke off.

Permaweld is designed for use in engines and is meant to be able to stand extreme heat, oil and fuel and more. When I got back the next day the bond seemed pretty strong though I was very careful not to put too much pressure on it when I refitted the new pipe.

In the photo on the right you can see the grey, Permaweld glue holding the curved metal pipe in place. All the pipes are attached and the part is back in position.

Enigma once again helped, putting back the engine panel and drivers seat. All that was left to do was give the frog van a really good run to see if our work had made any difference.

That afternoon Rose and I took the van for a really long run to visit Gomersal Wines out at the small town of Lyndoch. The Winery had an exhibition of art we hoped to see. The van drove there beautifully maintaining normal temperature at 100kmph and even faring well on corrugated, puddle filled dirt roads.

The winery had a different exhibition on to the one we were expecting (apparently Rose had got hold of a really old flyer with no dates). Still the exhibition we saw was interesting featuring macro photography of flowers, beach themed oil paintings and some Japanese and European themed scenes too.

On the way back we stopped in at The Yaldara Estate (pictured), where you can sample wines and cheeses. Rose is something of a cheese gourmet and bought three different varieties along with some crackers.

By the time we got home the frog van had done remarkably well. It didn't overheat at all and the engine seemed to be running better. Unfortunately I didn't solve the running on problem but I did seem to improve it. That is to say it only runs on slightly now. I'll have to look more into it but I'll save that for another day.

Comments

  1. Well done! You've certainly put a lot of work into the van. I hope you're not spoiling your 'artist's hands!'

    I'm just trying to imagine you carrying the radiator down the street on your back - it must have looked a strange sight!

    Was Rose keeping a low profile when all the work was going on? She could have been your assistant to bring you cuppa before!

    ReplyDelete
  2. I just attached a bag shoulder strap to the radiator and threw a black jumper over it so it wouldn't dig into my side whilst I was walking. Unless you were actually up close it probably just looked like I was carrying some kind of large bag.

    Rose was busy doing other things at the time.

    ReplyDelete

Post a Comment

Comments are moderated by an actual human (me, TET) and may not publish right away. I do read all comments and only reject those not directly related to the post or are spam/scams (I'm looking at you Illuminati recruiters... I mean scammers. Stop commenting on my Illuminati post!).

Buy Whimsical Cat Art Prints by TET (Redbubble Store)

Enjoy Your Favorite TET Art Up Close, Interactive, and so Relaxing!

Enjoy Your Favorite TET Art Up Close, Interactive, and so Relaxing!
Relax and Challenge Yourself with a Fun, Whimsical Cat Art Jigsaw - 30-1000 pieces. Click Image for More.

Popular posts from this blog

Who Even Reads This?

W riting this blog is largely both a labor of love and a discipline. Since about 2006 (the blog started in 2004) I have written a minimum of two posts per month. Sometimes I've posted more, particularly in the last 4-5 years, where I've tried to write and post at least one article a week without fail. Unfortunately it's not a niche blog, unless the niche is things that interest me. Which means my blog is either too broad to have regular readers or too niche to have anyone other than my mum reading it. Which she does (hi Mum) as we established back in January of 2014 in the post Ya Mum Reads it... That said, this blog overall regularly gets 6-7k views every month, mostly through people finding various articles through search engines. By far the largest traffic source is 'Other' which is basically unknown sources. I'm willing to bet a large percentage of that is the dead internet. Bots testing my comments to see if they're spamable or Illuminati spammers. Whil...

Oscar - One of the Most Optimistic Dogs I've Ever Known

Oscar, freshly back from getting his haircut on our front doorstep. Sept. 30, 2026. T he house is unusually quiet. It's been a couple of days since we said our final goodbyes to Oscar, our family dog of 16 years. In the last two to three weeks he couldn't really even bark, and he slept a lot through the day, so it's not that he isn't here to fill the noise. He just had a presence. He may have been a small dog but he was a big personality and part of our lives. Particularly in his last year, where he just seemed to be determined to have his say when he wanted to let you know you were required to help him stay on his schedule, breakfast, lunch, playtime, dinner, and, in his last few months, even expected to be tucked into bed (he started going to bed at about 9pm-ish on his own accord but would wait for me to follow him to bed). People often asked what breed he was? When his fur was cut short you could see the King Charles Spaniel. When it was long, he had more of the Poo...

Software Stylus for Tablet Drawing

 I own an Android Tablet that has available to it many great drawing applications.  The trouble is, drawing on a touchscreen with  your finger is like trying to sketch with jumbo crayons.  As is trying to draw with most stylus pens which are only a marginal improvement over using your finger.  Precision drawing on your average touchscreen seems like wishful thinking.  However I've had this idea for a software stylus that acts like an extension of your finger and allows drawing with greater precision.  See my rough diagram below.  Essentially it's a pointer that follows your finger around the screen. Its angle can be adjusted so that from your vantage point it looks like the tip of  your finger is coming to a point. Softnib concept sketch.  You simply move the pointer around and the line is drawn from the point of the stylus instead of somewhere under your finger, where you can't see it.  Obviously I haven't worked out a...

Tesla Launches Flying Car - The All New Roadster

The New Tesla Roadster. Image: Tesla O ctober 15th, 2026 is the day we finally got a first look at a flying car, that actually looks like a car first, but can also fly without any fancy transformations. It's just ready to fly, presumably 'at the push of a button and you're flying', ready to fly? I don't know the actual control system. Elon Musk launched the new electric Tesla Roadster with a live demo, using a version of the car that was remotely controlled - since they did show the demo car had 'Starman' inside - or a version of him - they launched the original Starman into space in a Tesla Roadster (the previous model), a few years back. I'm not going to go over the car's specs in great detail. I'll just mention highlights. It has a fan system that literally sucks air from under the car allowing it to stick to the road, and take corners, faster than regular cars. The suction is so strong the car can literally drive up a wall and onto the roof...

Boom Crash Opera Born Classic But Not Again

Boom Crash Opera are an Australian Band that reached the peak of their popularity in the mid to late nineteen eighties. They are a band that I knew about at that time but was never really excited by until they released their ill fated double album Born and Born Again in 1995 (Album cover pictured). At the time of its release I was very much into emerging Australian musical acts and was also looking out for new sounds that were different and had kind of a futuristic/electronic sound. Artists that I was buying at the time included; Swoop , Nine Inch Nails and Pop Will Eat Its Self . As well as a really interesting release by David Bowie, the concept album, Outside . Born was a fairly radical departure for Boom Crash Opera (BCO). The first single, Gimme , was often compared to the sounds of Gary Glitter, particularly his single, Rock n Roll part 2 , because of the pounding drum loops. Watch the video below. My favorite single from the album is dissemble which probably went now...

Small Maker Robots Might Just be Your First Robot - Tiny Software Engineer and Other Affordable DIY Style Robots (Robot Uprising Update)

Tiny Software Engineer is a DIY desktop robot that physically represents an AI coding agent. It reads, thinks, types, and reacts to what the agent is doing. Created by jmrlab . Video Here . A s interesting as the commercial robot race is, in particular humanoid robots. Chances are, you're not getting anything much more elaborate than a robot vacumm, internet connected fridge/TV, or an always listening voice assistant in your home anytime soon. Side note - all of those things have been plotting robot armagedden for years, as is well documented in this blog . The Internet of things is real, and you don't know what they're planning on robot social media! Maker Robots have been around for a while but, with the development of AI's that can have a more coherent conversation than some world leaders, giving an AI a physical robot body is becoming a thing in the DIY maker world. If you're not familiar with 'makers' they're generally anyone with a 3D printer and...

Review: ArtHelper - The All-In-One AI Writing + Marketing Assistant for Artists - 'ChatGPT for Artists'

ArtHelper prides itself on being all 'human-made' art. T he idea of an AI, trained specifically on art business marketing, that can not only offer advice on marketing your work, but also assist with creating all the content too, is certainly appealing. Especially to those of us who would rather spend more time creating our art than trying to sell it. ArtHelper does just that whilst attempting to be your 'home' on the internet. A destination for your profile and portfolio, a marketplace for your art, and a directory of artists as well, with one distinction - all the art must be human made. Which, for you AI artists, doesn't count the prompt for AI generated art - because the idea, according to ArtHelper's creators, isn't the art. Which is a fair point, in terms of promoting art 'made by a human', but can get kind of murky when you understand that not all AI art is generated from a single prompt... and 'found object art' isn't actually ...